Next step will be to focus on the backside wall and the backside of the PSU shroud. You can mount these plates on top of the shroud cover, on the right side of your motherboard tray, and to cover drive cags. The Addressable RGB LEDs run along the top 1/2' and the cable comes out the top right corner. I had a real drill bit that I loaded into my drill driver and tried to keep both a steady hand and not go to deep and cut through. Our PSU Shroud Side Covers are designed to mount on top of your existing PSU Shrouds using included double-sided tape. The last thing left to fix on the front of the PSU shroud was to make room for the head of the screw I need to keep my PSU brackets in place. Took some measurements and cut the front part of the shroud open after the rhombus shape. It also brakes up the flat surface of the PSU shroud in balance to the pump cover. The rhombus shape with the design of also making it smaller the further in it goes is a real eye catcher towards the logo and the PSU. Had an idea and made a design in Fusion and loaded the printer. It’s both wrong and wouldn’t be true to my original concept – Unhidden | Tribute. I can’t hide the beautiful PSU behind a shroud wall. Now the pump is even more in focus and the over all design is less boxy. I cut my shroud open after the pump cover and I felt I had made a great improvement. I felt I had to make some change as it felt a little to flat and boring.Īfter going back to the original shroud from Cooler Master and it’s angled design with a more narrow top I had my inspiration and tribute. The pump is what draws attention, but still keep it classical with a PSU shroud. First print is a faster prototype profile. Custom PSU Shroud Build/How to - Cases and Mods - Linus Tech Tips So finally after being tired of seeing nothing but wires in my Corsair 760t, I decided it was time to make my own custom PSU shroud/basement. This is how I want to show the unhide the pump, but still keep it as clean as possible. After some time I felt I had a solid solution. Knew what I wanted as an end result, but not sure of the road to it. I started testing different design ideas and print solutions. Work continued with the front part of the PSU shroud and the specifically the pump cover.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |